Samsung DMS790BUB Manuel d'utilisateur télécharger pdf (Page 13)

using the detergent and water softener _13

03 DETERGENT AND WATER SOFTENER

LOADING OF REGENERATING SALT

Loading of regenerating salt

Filling with salt is essential for providing a good wash without marks. It regenerates the resins

that soften the water, by removing its lime content (unless the mains water supply is soft

enough). Refer to “Setting the water softener”.

Only use special dishwasher regenerating salt. Do not use table salt or any type of cooking

salt, this could damage your appliance’s water softener.

 Unscrew and remove the stopper on the salt tank.

 Fill the tank with regenerating salt specially designed for

dishwashers.

 Use the funnel supplied with your dishwasher. The ﬁrst

time, top up with water up to the rim of the tank.

Regenerating salt indicator:

This illuminates when salt must be added.

After the tank has been ﬁlled with regenerating salt, the indicator light may remain lit until the salt

has dissolved sufﬁciently, usually after one cycle (of if the tank has not been ﬁlled completely; for

example, when ﬁrst putting the machine into service using the sample).

This can be deactivated as indicated in the paragraph “For multi-purpose products” setting

table.

If the salt overﬂows when ﬁlling the tank, to avoid oxidization of the tub it is advisable to

remove the salt crystals or to run a Soaking programme.

DMS790BUB_EN.indd 13 2009-08-07  10:13:30

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

Samsung DMS790BUB Manuel d'utilisateur Page 13