Samsung DV48J7700GW Manuel télécharger pdf (Page 13)

English 13

Installation

Location considerations

Locate the dryer where there is enough space at the front for loading the dryer, and enough

space behind for the exhaust system. This dryer is factory-ready for rear exhaust. To exhaust

out the bottom or the right or the left (electric model only), use the accessory exhaust kit

(sold separately). Instructions are included with the kit. It’s important to make sure the room

has enough fresh air. The dryer must be located where there is no air-ow obstruction.

On gas dryers, adequate clearance as noted on the data plate must be maintained to ensure

adequate air for combustion and proper dryer operation.

Do not install or store the dryer in an area where it will be exposed to water and/or weather.

Keep the dryer area clear of combustible materials, gasoline, and other ammable vapors and

liquids. A dryer produces combustible lint. The area around the dryer should be kept lint free.

Alcove or closet installation

Minimum clearances between the dryer and adjacent walls or other surfaces are:

2” in front, 17” on top, 1” on either side, and 5” in the back.

The closet front must have two unobstructed air openings for a combined minimum total area

of 72 in² with 3” minimum clearance on the top and bottom. A louvered door with equivalent

space clearance is acceptable.

WARNING

• You must exhaust the dryer to the outside to reduce the risk of re when you install the

dryer in and alcove or closet.

• To reduce the risk of re, you must exhaust the dryer to the outdoors.

See "Exhausting" section.

• No other fuel-burning appliance should be installed in the same closet as the dryer.

DV7700J-03170Q-03_EN-US.indd 13 2015/9/14 13:32:34

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 191 192

Pas de commentaire

Samsung DV48J7700GW Manuel Page 13