Samsung NP-R40P Manuel d'utilisateur télécharger pdf (Page 144)

Troubleshooting 125

Wired LAN Related

Q1 <Wake On LAN> function

A <Wake On LAN> function is a function that activates the system in rest

mode(S3) when a signal (such as a Ping or Magic Packet commands) arrives from

network(wired LAN).

To use <Wake On LAN> function:

1. Select My Network Places > View network connections from the Desktop.

2. Click the right button on the touchpad over Local Area Connection, and select

Properties.

3. Click Configure, and select Power Management tab. Select ’Allow this device

to bring the computer out of standby’, then click OK. Restart the system.

- If the system in rest mode is activated when there is no received signal, use the

system after disabling <Wake On LAN> function.

- If you turn the power off when <Wake On LAN> is disabled, the LAN LED

may continue to be lit up.

- Connecting wired LAN while using wireless LAN may not execute <Wake On

LAN> function. Configure wireless LAN to ’Disable’ to use <Wake On LAN>

function.

1. Click on My Network Place> View network connections on the Desktop.

2. Right-click over Wireless Network Connection and select Disable.

Q2 When I connected 100Mbps wired LAN and the computer exits standby/

hibernate mode, a message informing 10Mbps wired LAN connection

appears.

A When the computer exits standby/hibernate mode, restoring the network takes

about 3 seconds. When the network is restored, it operates in 100Mbps.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 341 342

Pas de commentaire

Samsung NP-R40P Manuel d'utilisateur Page 144