Samsung TS-H352A Manuel d'utilisateur télécharger pdf (Page 10)

Connecting the Cables

Setup

Connecting the Cables

Connecting the power cable

The 4-pin power cable from the internal power unit of your computer must be connected to the power

terminal on the rear of the Optical drive drive.

A - Cut S-IDE

1 +5V DC

2 Ground

3 Ground

4 +12V DC

Note: An improperly connected power cable may cause trouble. Check the direction of the power connector

and the incline S-IDE of the Optical drive before connecting.

Connecting the E-IDE cable

Insert the E-IDE cable (40-pin), which is connected to the hard disk to the interface terminal.

(Place the red line of the cable close to the Pin 1.)

When using one E-IDE cable

Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at the rear of the Optical

drive.

a : Slave Drive (Choose the SL Jumper)

b : Hard Drive

c : MainBoard

When using two E-IDE cable

If there is only one Optical drive, select MA (Master).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Samsung TS-H352A Manuel d'utilisateur Page 10