Samsung MWR-WS00 Manuel d'utilisateur télécharger pdf (Page 8)

E-8

Selecting the Heating Mode

Select the heating mode to raise the room temperature.

Press the (ON/OFF) button to turn on the indoor unit.

(Do not press the (ON/OFF) button if the remote

controller is on).

Result

: The air-conditioner will be turned on with the

mode selected when the unit was last used.

Caution The air-conditioner has a built-in protection

mechanism to prevent the unit from being

damaged when it is started immediately after

being:

 Plugged in

 Stopped

The air-conditioner will start up after 3 minutes.

To select the HEAT mode, press the button until Heat is

displayed on the remote controller.

Result

: The air-conditioner will run in heating mode.

To adjust the temperature, press the buttons to set

the desired temperature.

The temperature can be set between 16°C and 30°C.

Result

:  The temperature is adjusted by 1°C when

the buttons are pressed.

 The air-conditioner will start heating if

the temperature set is higher than the room

temperature.

 The fan will run even if the temperature set is

lower than the room temperature.

Select the fan speed by pressing the button.

To adjust the airflow direction, refer to page 13.

Note Cooling and heating mode cannot be selected at

the same time.

The heating mode can be selected only on the heat pump models.

MWR-WS00_IB_E_25179.indd 8 2006-03-28 ｿﾀﾈﾄ 3:26:50

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Pas de commentaire

Samsung MWR-WS00 Manuel d'utilisateur Page 8