Samsung HCP4363WX-XAC Manuel d'utilisateur télécharger pdf

Connecting VHF and UHF Antennas

INSTALLATION

Chapter Two

Place the wires from the twin

leads under the screws on the

300-75 ohm adaptor (not

supplied). Use a screwdriver

to tighten the screws.

Plug the adaptor into the “ANT

1 IN” terminal on the rear

panel.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has 300-ohm

twin flat leads, follow the directions below.

Plug the antenna lead into the

“ANT 1 IN” terminal on the

rear panel.

Antennas with 75-ohm Round Leads

Connect both antenna leads to the combiner.

Plug the combiner into the “ANT 1 IN” terminal on the rear

panel.

Separate VHF and UHF Antennas

If you have two separate antennas for your TV (one VHF and one UHF), you must combine

the two antenna signals before connecting the antennas to the TV. This procedure requires an

optional combiner-adaptor (available at most electronics shops).

BP68-00342A-00Eng_TV 4/6/04 3:02 PM Page 11

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Chapter Two

Connecting VHF and UHF AntennasINSTALLATIONChapter Two1Place the wires from the twinleads under the screws on the300-75 ohm adaptor (notsupplied). Use

Page 2 - Connecting Cable TV

INSTALLATION1Find the cable that isconnected to the ANTENNAOUT terminal on your cablebox.2Connect the other end of thiscable to the “ANT 1 IN”terminal

Page 3 - INSTALLATION

INSTALLATION1Find and disconnect the cablethat is connected to theANTENNA IN terminal on yourcable box.Connecting to a Cable Box that Descrambles Some

Page 4 - Connecting a VCR

INSTALLATIONConnecting a VCRThese instructions assume that you have already connected your TV to an antenna or a cableTV system (according to the inst

Page 5 - Connecting a DVD Player

INSTALLATIONConnecting a DVD PlayerThe rear panel jacks on your TV make it easy to connect a DVD player to your TV.Connecting to Y, PB, PR1Connect a s

Page 6

INSTALLATIONConnecting a Digital TV Set-Top BoxThe rear panel jacks on your TV make it easy to connect a Set-Top Box to your TV.Connecting to Y, PB, P

Page 7

INSTALLATIONConnecting to DVI (Digital Visual Interface)By inputting a high-bandwidth digital content protection high-definition picture source to the

Page 8 - Connecting a Camcorder

INSTALLATIONConnecting a CamcorderThe side panel jacks on your TV make it easy to connect a camcorder to your TV. They allowyou to view the camcorder