Samsung SP-A8000 Manuel d'utilisateur

SP-A8000DLP ProjectorOwner’s InstructionsThe color and the appearance of the product may differ from the illustrations in this manual. The specificati

2-1 Installation and Connection2 Installation and Connection2-1 Package Contents • Unpack the product and check if all of the contents listed below ha

Installation and Connection 2-1 A ceiling mount is not included and must be purchased separately. Use the included screws to attach the projector to t

2-2 Installation and Connection2-2 Installing the Projector Install the projector so that the beam from the projector is perpendicular to the screen.•

Installation and Connection 2-32-3 Leveling with Adjustable Feet • You may adjust the level of the projector up to 3 degrees.• Depending on the posit

2-4 Installation and Connection2-4 Zoom and Focus Adjustment If you install your projector at a location beyond the projection distances specified fo

Installation and Connection 2-52-5 Adjusting the Lens Position Moving DialMove the picture projected on the screen up and down within the lens range b

2-6 Installation and Connection2-6 Screen Size and Projection Distance Install the projector on a flat, even surface, and then level the projector usi

Installation and Connection 2-6 This projector is designed to show images optimally on a 100 ~ 120 inch sized screen. 250 635.0 217.9 553.5 122.6 311.

2-7 Installation and Connection2-7 Lamp ReplacementCautions on Lamp Replacement• The projector lamp is an expendable item. For best operating performa

Installation and Connection 2-73. Open the cover by holding down and pulling .4. Remove the screws , and then hold and open to remove the lamp do

Table Of ContentsMAJOR SAFETY PRECAUTIONSBefore You Start . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1C

2-8 Installation and Connection2-8 Supported Display Modes2-8-1. PC Timing (D-Sub/HDMI) FORMAT RESOLUTIONDISPLAY FORMATHORIZONTAL FREQUENCY(KHZ)VERTIC

Installation and Connection 2-8 All resolutions higher or lower than 1920x1080 are converted to 1920x1080 by the Scaler chip inside the projector. If

2-8 Installation and Connection2-8-3. AV Timing(HDMI)2-8-4. AV Timing (VIDEO)NTSC, NTSC 4.43, PAL, PAL60, PAL-N, PAL-M, SECAMYour projector supports t

Installation and Connection 2-92-9 Connecting the Power- Plug the power cord into the power terminal on the rear side of the projector.

2-10 Installation and Connection2-10 Connecting a DVD player/Cable Box/Satellite Box to HDMI/DVIMake sure that your projector and DVD player/Cable box

Installation and Connection 2-112-11 Connecting a DVD player/Cable Box/Satellite Box via ComponentMake sure that your projector and DVD player/Cable b

2-12 Installation and Connection2-12 Connecting to VCR/CamcorderMake sure that your projector and VCR or camcorder are turned off and unplugged.1. Con

Installation and Connection 2-132-13 Connecting with a PC and Setting up the PC2-13-1. Setting up the PC Environment Check the following items before

2-13 Installation and Connection5. Click the [OK] button to close the window, and then click the [OK] button on the <Display Properties> window

Installation and Connection 2-142-14 The 3D IR EmittersYour projector comes with a built-in 3D emitter, which is located on the front of the projector

1 Major Safety Precautions1-1 Before You StartIcons used in this manualUsing this Manual• The contents of this manual are subject to change without pr

2-14 Installation and ConnectionView Angles • The range of the 3D function may differ slightly depending on the projector size, projection distance, a

Installation and Connection 2-142. Installation ProcedureTo install the external 3D IR emitter on the ceiling, follow these steps: • Disassembly is in

3-1 Using3Using3-1 Product Features 1. Optical engine with advanced DLP technology • Full 1920x1080 HD panel. • 6 segment color wheel to implement opt

Using 3-23-2 Front, Upper The buttons on the top of the projector are touch buttons.Touch them lightly with your fingers to use them. ICON NAME DESCRI

3-3 Using3-3 Rear SideICON NAMEPC IN Input port COMPONENT IN 1 / COMPONENT IN 2 portsRemote Control Signal Receiver3D SYNC OUT (connects to an externa

Using 3-43-4 Remote Control Using your projector with another remote control device nearby may result in improper functioning due to remote control

3-4 UsingInstalling Batteries in the Remote Control1. Lift the cover at the back of the remote control upward as shown in the figure.2. Insert two AA

Using 3-53-5 LED Indications LED Indications :Light is On :Light is Blinking :Light is OffSTAND BY LAMP TEMP INFORMATIONIf you press the POWER butto

3-5 UsingClearing Indicator Problems This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may cau

Using 3-63-6 Using the Screen Adjustment Menu (OSD: On Screen Display) The Screen Adjustment Menu (OSD: On Screen Display) StructureTo access the Menu

1-2 Care and MaintenanceCleaning the Surface and the LensCleaning Inside the ProjectorClean the projector using a soft dry cloth.• Do not clean the pr

Using 3-6MENU DESCRIPTION3D Enjoy dynamic 3D images by using Samsung 3D glasses. Be sure to read "3-7 Read Before Watch-ing 3D Picture" thor

3-6 Using3D • <3D View Point> : The overall adjustment of 3D perspective. This function is deactivated when <3D Mode> is set to (2D → 3D)

Using 3-6Mode Select a screen mode to match the environment, the kind of images you are projecting, or select a customized mode you have created based

3-6 UsingScreen• <Coarse> / <Fine> : Removes or reduces picture noise. If the noise is not removed by Fine-tuning alone, then adjust the f

Using 3-6Picture Options• <Size>You can select a screen size according to the type of scene.<16:9> - <Zoom1> - <Zoom2> - <W

3-6 Using3-6-2. SetupMENU DESCRIPTIONMenu Language Set the menu language.No Signal Power Off To avoid unnecessary energy consumption, set how long you

Using 3-6Test PatternGenerated by the projector itself. Utilize as standards to optimize the installation of the projector. • <Crosshatch> : Hel

3-6 Using3-6-3. Input3-6-4. SupportMENU DESCRIPTIONSource List You can select a device connected to the projector to display.• <PC> - <Video&

Using 3-73-7 Read Before Watching 3D PictureIMPORTANT HEALTH AND SAFETY INFORMATION FOR 3D PICTURES.Be sure to read and understand fully the following

4-1 Troubleshooting4 Troubleshooting4-1 Before Requesting Service Please check the following before requesting After-Sales service. If the problem con

Major Safety Precautions 1-31-3 Safety PrecautionsIcons used for safety precautionsMeaning of SignsPower Related The following images are for your re

Troubleshooting 4-1Screen and External Source Cannot see picture images. Be sure that the power cord of the projector is connected.Confirm that the pr

5-1 More Information5 More Information5-1 Specifications This Class B equipment is designed for home and office use. The equipment has been registered

More Information 5-25-2 RS232C Command TableCommunication Format (Complies with the RS232C Standard)• Baud rate : 9,600 bps • parity : None• Data bits

5-2 More InformationCommand TableCONTROL ITEM CMD1 CMD2 CMD3 VALUEGeneral Power Power Display OSD / Power On0x00 0x00 0x00 0OK 1Cancel 2Input Source L

More Information 5-35-3 Contact SAMSUNG WORLDWIDE If you have any questions or comments relating to Samsung products, please contact the SAMSUNG custo

5-3 More InformationCZECH 800 - SAMSUNG (800-726786) http://www.samsung.comDENMARK 70 70 19 70 http://www.samsung.comEIRE 0818 717100 http://www.samsu

More Information 5-3KAZAKHSTAN 8-10-800-500-55-500 (GSM: 7799) http://www.samsung.comKYRGYZSTAN 00-800-500-55-500 http://www.samsung.comMOLDOVA 00-800

More Information 5-3TURKEY 444 77 11 http://www.samsung.comU.A.E 800-SAMSUNG (726-7864) http://www.samsung.comAFRICANIGERIA 0800 - SAMSUNG (726-7864)

5-4 More Information5-4 Correct Disposal - Europe onlyCorrect Disposal of This Product (Waste Electrical & Electronic Equipment) - Europe only Cor

1-3 Major Safety PrecautionsCautionInstallation Related WarningWhen unplugging the power plug from the wall outlet, make sure to hold the power plug b

Major Safety Precautions 1-3CautionUsage RelatedTake care not to block the vent with a table cloth or curtain.• Doing otherwise may result in fire due

1-3 Major Safety PrecautionsCautionIf the product generates a strange noise, a burning smell, or smoke, unplug the power plug immediately and contact

Major Safety Precautions 1-3To avoid burning yourself, do not touch the vents or lamp cover while operating or right after turning off the product.Do