Samsung XAA Manuel de service télécharger pdf (Page 25)

4-4

EEPROM Reset Mode:

1. EEPROM can be reset once the user enters the EEPROM Clear Mode.

2. If there is any problem with EEPROM, 7-Segment will display “ FAiL ”. “Good”

will be displayed if everything is OK.

3. PCB assy. needs replacing if “FAiL” is displayed during EEPROM reset.

4. If PCB assy. is replaced for some reason, EEPROM needs resetting.

5. If problem occurs with Sticky Function, My Cycle and Power Failure

Compensation, it may be due to EEPROM .

Check EEPROM’s condition at EEPROM Clear Mode.

4-2-2. EEPROM Reset Mode

Deﬁnition of EEPROM Reset Mode:

- EEPROM initialization.

- All course/option settings are to be reset to default values after EEPROM initialization.

- When Service arises and it needs PCB replacement, EEPROM should be reset.

How to Enter:

- The unit needs to be on.

- Press Delay Start Key, Signal Key and Power Key at the same time.

(Same for all Frontier models.)

4-2-3. Continuous Run Mode

Continuous Run Mode:

1. Press Delay Start + Extra Rinse Key for 3 sec during Power On State (Normal User Mode) .

2. Once in Continuous Run Mode, 7-Segment will blink “cc” and the remaining time in turns.

3. The Continuous Run Mode will repeat the previous cycle until continuous run mode is cancelled.

4. During Continuous Run Mode, press Delay Start + Extra Rinse Key for 3 seconds to return to normal user mode.

7-segment will no longer display “cc”, but only display the remaining time.

Deﬁnition of Continuous Run Mode:

- Will continuously repeat the current cycle until the Continuous Run Mode is cancelled.

How to Enter:

- Press Delay Start Key and Extra Rinse Key together for 3 sec.

(Same for all Frontier models.)

4-2-4. Special Test Mode

Deﬁnition of Special Test Mode:

- Special Test Mode enables service technicians to verify the operation of the washing machine and do troubleshooting.

- Special Test Mode can be entered during all washing cycle without interrupting the cycle except some of test modes.

- Various tests can be done with Special Test Mode. So, troubleshooting can be done based on the resulting diagnostic codes.

How to Enter:

- To enter the Special Test Mode, press the Signal and Extra Rinse Keys for 3 seconds or until the unit sends out

beeping sounds. (same for all Frontier models.)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 88 89

Pas de commentaire

Samsung XAA Manuel de service Page 25