Samsung DV457GVGSGR-AA Manuel d'utilisateur télécharger pdf (Page 19)

English - 19

02 INSTALLING YOUR DRYER

Method 2

The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old

hoses.

1. If the “Y” connector cannot be attached directly to the cold

water faucet, the short hose must be used.

2. Turn the cold water faucet o .

3. Attach the short inlet hose to the cold water faucet.

Screw on the coupling by hand until it is seated on the

faucet.

4. Using the pliers, tighten the coupling with an additional two-

thirds turn.

Do not overtighten, as this may damage the coupling.

5. Attach the ‘Y” connector to the brass male end of the small

hose. Screw on the coupling by hand until it is seated on the

connector.

6. Using the pliers, tighten the coupling with an additional two-

thirds turn.

Do not overtighten, as this may damage the coupling.

7. Attach the angled end of long hoses to the ﬁ ll valve at the

bottom of the dryer rear frame. Screw on the coupling by

hand until it is seated on the ﬁ ll valve connector.

8. Using pliers, tighten the coupling with an additional two-

thirds turn.

Do not overtighten, as this may damage the coupling.

9. Check that the water faucets are on.

10. Check for leaks around the “Y” connector, faucets and

hoses.

Short hose

(Inlet to cold

water)

“Y” connector

Long hose

Duct Exhaust

Frame

(back)

Water Hose

DV457E(G)_02836E-08_EN.indd 19DV457E(G)_02836E-08_EN.indd 19 2014-04-28  6:13:162014-04-28  6:13:16

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 227 228

Pas de commentaire

Samsung DV457GVGSGR-AA Manuel d'utilisateur Page 19