Chapter 6 Image Managemen
6-27
4. Use the trackball to move the cursor to another location and press the Set button to set the end
point.
▶
Press the Change button before assigning the end point to change the position of the start point.
The distance between the two points will be displayed on the screen.
▶
You can use the same method to take multiple measurements. Note that the measurement results
are not saved with the image.
5. To nish measurement, press the Exit button on the control panel or Close on the screen.
Ellipse
Use this function to draw an ellipse over the 2D image, and then measure the perimeter and area of the
ellipse.
1. Press Ellipse on the Exam Review screen.
2. Place the cursor over the image and press the Set button. The image will be displayed in full screen
view.
3. Move the cursor to a desired location and press the Set button to set the start point.
4. Use the trackball to move the cursor to another location and press the Set button to set the end
point. Press the Change button before assigning the end point to change the position of the start
point.
5. After adjusting the size of the ellipse, press the Set button to confirm the size of the ellipse. The
perimeter and area of the ellipse will be displayed on the screen.
▶
You can use the same method to take multiple measurements. Note that the measurement results
are not saved with the image.
6. To nish measurement, press the Exit button on the control panel or Close on the screen.
Layout
Use this function to congure the number of images to show on the Exam Review screen.
On the Exam Review screen, press Layout and select items from Single to 3*3 in the Image Layout window.
Closing SONOVIEW
Press the SONOVIEW button or click X on the screen to close SONOVIEW.
Commentaires sur ces manuels