Samsung C61R2CCN Manuel d'utilisateur télécharger pdf (Page 226)

Installing the Hob

Important: Be sure the new appliance is installed and grounded only by qualied

personnel.

Please observe this instruction. The warranty will not cover any damage that may

occur as a result of improper installation.

Technical data is provided at the end of this manual.

Safety instructions for the installer

• A device must be provided in the electrical installation that allows the appliance to be discon-

nected from the mains at all poles with a contact opening width of at least 3 mm. Suitable

isolation devices include line protecting cut - outs, fuses (screw type fuses are to be removed

from the holder), earth leakage trips and contactors.

• With respect to re protection, this appliance corresponds to EN 60 335 - 2 - 6. This type of

appliance may be installed with a high cupboard or wall on one side.

• Drawers may not be tted underneath the hob.

• The installation must guarantee shock protection.

• The kitchen unit in which the appliance is tted must satisfy the stability requirements of DIN

68930.

• For protection against moisture, all cut surfaces are to be sealed with a suitable sealant.

• On tiled work surfaces, the joints in the area where the hob sits must be completely lled with

grout.

• On natural, articial stone, or ceramic tops, the snap action springs must be bonded in place

with a suitable articial resin or mixed adhesive.

• Ensure that the seal is correctly seated against the work surface without any gaps. Additional

silicon sealant must not be applied; this would make removal more difcult when servicing.

• The hob must be pressed out from below when removed.

C61R2CAST_BOL_00121B-04_BG+HR+MK+RO+SR+SL+EN.indb 10 2016-11-28  12:09:49

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 251 252

Pas de commentaire

Samsung C61R2CCN Manuel d'utilisateur Page 226