4-110
Operation Manual
MagiCut
NOTE:
X
Select this in MPR mode.
X
If MagiCut is enabled, Accept ROI is turned on automatically.
X
After MagiCut is enabled, if the system is switched to a mode other than MPR Mode, MagiCut
is disabled.
The MagiCut screen is displayed on the touch screen. Cut the parts that are not relevant to diagnosis
from 3D images. Set the area to cut by using the trackball and the Set button.
■
Mode
Set how parts are cut by clicking the corresponding button on the touch screen.
X
Inside Contour: Cuts the inside of the selected area.
X
Outside Contour: Cuts the outside of the selected area.
X
Inside Box: Cuts the inside of the box.
X
Outside Box: Cuts the outside of the box.
X
Small Eraser: Cuts the selected contour line.
X
Big Eraser: Cuts the selected contour line (thicker than Small Eraser).
■
Full Depth
Click the touch screen to turn it on or off. If it is turned on, the entire area will be cut. If it is turned
off, Depth will appear on the touch screen.
■
Depth
Set the cut depth. Select a value between 1 and 100 by clicking the corresponding button or using
the dial-button on the touch screen.
■
Undo
Cancel the previous task(s).
X
Undo: Cancel the last task.
X
Undo All: Cancel all tasks that have been done so far.
Commentaires sur ces manuels