5-20
Operation Manual
Volume Measurement
NOTE: Since Dual Mode simultaneously displays two images on the screen, you don’t have to
return to the diagnosis mode to measure volume in Dual Mode.
3 Distance Vol.
This is a basic measurement that is available in all diagnosis modes. You can measure the volume of
an object in a 2D image by using 3 straight lines.
1. Press the 3 Distance Vol. button on the touch screen. “3 Distance” is displayed in the user
information area.
2. Specify two points and measure the straight distance between them. The method for measuring
a line is the same as in “Distance.”
3. Measure the length of the remaining two straight lines as in the above. Measure other two
distance using the same method with 2.
4. When the measurement is nished, its result is shown on the screen. The volume of the object
along with the length of each straight line are calculated.
X
Press the Undo button on the touch screen to cancel the current measurement and take it
again.
The equations used for 3 Distance measurement are as follows:
MOD Vol.
A basic measurement that is available in all diagnosis modes. In a 2D image, the area of an irregular
object and the length of its long axis are obtained to calculate its volume. MOD is an abbreviation for
‘Method of Disk.’
1. Tap the MOD Vol. on the touch screen. ‘MOD’ will appear in the user information area.
2. Draw a contour to measure. The way it is measured is the same as in ‘Trace.’
3. Measure the length of the long axis. The way it is measured is the same as in ‘Distance.’
Commentaires sur ces manuels